Dell Force10 Z9000 - Page 1143

Example
(Address)
FTOS#sh ip pim rp 229.1.2.1
Group RP
229.1.2.1 165.87.20.4
FTOS#
show ip pim tib
View the PIM tree information base (TIB).
C-Series, E-Series, S-Series, S4810
Syntax
show ip pim tib [group-address [source-address]]
Parameters
group-address (OPTIONAL) Enter the group address in dotted decimal format
(A.B.C.D).
source-address (OPTIONAL) Enter the source address in dotted decimal format
(A.B.C.D).
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip pim tib command shown in the Example below.
Field Description
(S, G) Displays the entry in the multicast PIM database.
uptime Displays the amount of time the entry has been in the PIM route
table.
expires Displays the amount of time until the entry expires and is removed
from the database.
RP Displays the IP address of the RP/source for this entry.
flags List the flags to define the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
1143