Enterasys Matrix DFE-Gold Series

clear inlinepower mode Configuring Power over Ethernet (PoE)
Enterasys Matrix DFE-Gold Series Configuration Guide 2-63
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtosetthechassispowerallocationmodetomanual:
Matrix(rw)->set inlinepower mode manual
clear inlinepower mode
Usethiscommandtoresetchassispowerallocationtothedefaultmodeofauto.
Syntax
clear inlinepower mode
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthechassispowerallocationmodetoauto:
Matrix(rw)->clear inlinepower mode
set inlinepower available
Usethiscommandtosetthepercentageoftotalpoweravailablethatachassiscanwithdrawfrom
thetotalpowerdetected.
Syntax
set inlinepower available max-percentage
auto Assignsautomaticmodetochassispowerallocation.
manual Assignsmanualmodetochassispowerallocation.Thissettingallows
thevaluesconfiguredwiththesetinlinepowerassignedcommand
(“setinlinepowerassigned”onpage 2 ‐66)tobeappliedtoPoE
modules.