Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Bridge Parameters show spantree maxconfigurablestps
6-12 Spanning Tree Configuration
Example
ThisexampleshowshowtoresettheSTPmodetoIEEE802.1:
Matrix(rw)->clear spantree stpmode
show spantree maxconfigurablestps
UsethiscommandtodisplaythesettingforthemaximumnumberofuserconfigurableSpanning
Treeinstances.
Syntax
show spantree maxconfigurablestps
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheSTPmaximumconfigssetting:
Matrix(rw)->show spantree maxconfigurablestps
Max user configurable stps is set to 33
set spantree maxconfigurablestps
UsethiscommandtosetthemaximumnumberofuserconfigurableSpanningTreeinstances.
Syntax
set spantree maxconfigurablestps numstps
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
numstps SpecifiesthemaximumnumberofuserconfiguredSTPstobeallowed
onthisbridge.Validvaluesare1‐9.