Enterasys Matrix DFE-Gold Series

show nodealias config Configuring Node Aliases
Enterasys Matrix DFE-Gold Series Configuration Guide 14-5
Parameters
Defaults
•Ifip‐addressisnotspecifiedfortheIPprotocol,IP‐relatedentrieswillbedisplayedfromall
sourceaddresses.
•Ifport‐stringisnotspecified,nodealiasentrieswillbedisplayedforallports.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaynodealiasentriesforIPtrafficonge.3.16.Referbackto
Table 14‐1foradescriptionofthecommandoutput.
Matrix(rw)->show nodealias protocol ip ge.3.16
Port: ge.3.16 Time: 1 days 03 hrs 33 mins 47 secs
--------------------------------------------------------
Alias ID = 1533917141 Active = true
Vlan ID = 1 MAC Address = 00-e0-63-04-7b-00
Protocol = ip Source IP = 199.45.62.25
show nodealias config
Usethiscommandtodisplaynodealiasconfigurationsettingsononeormoreports.
Syntax
show nodealias config [port-string]
Parameters
ip|apl|mac|hsrp|
dhcps|dhcpc|
bootps|bootpc|
ospf|vrrp|ipx|
xrip|xsap|ipx20|
rtmp|netBios|nbt|
bgp|rip|igrp|dec
|bpdu|udp
Specifiestheprotocolforwhichto
displaynodealiasentries.Refer back
shownodealiasmac(“shownodealiasmac”onpage 14‐2)fora
detaileddescriptionoftheseparameters.
ip‐addressip‐address (Optional)UsedforIPprotocolonly,displaysnodealiasentriesfora
specificsourceaddress.
port‐string (Optional)Displaysnodealiasentriesforspecificport(s).
Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
port‐string (Optional)Displaysnodealiasconfigurationsettingsforspecific
port(s).Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage 4‐2.