Enterasys Matrix DFE-Gold Series

Configuring Network Address Translation (NAT) clear router limits (NAT)
18-16 Network Address Translation (NAT) Configuration
Route Table Limit - 12000 (default)
TWCB maximum Bindings - 32000 (default)
TWCB Cache size - 2000 (default)
TWCB maximum Configs - 1 (default)
ThisexampledisplaystheNATcache‐sizelimitforthissystem:
Matrix(su)->show router limits nat-cache
NAT Cache size - 2000 (default)
clear router limits (NAT)
UsethiscommandtoresetNATrouterlimitstothedefaultvalues.
Syntax
clear router limits [nat-bindings] [nat-cache] [nat-dynamic-config]
[nat-static-config] [nat-interface-config] [nat-global-addr-cfg]
[nat-global-port-cfg]
Parameters
Defaults
Ifnoparametersarespecified,allrouterlimitsarereset,includingTWCB,LSNATandroute‐table
routerlimits.
Mode
SwitchCommand:Matrix(rw)‐>.
Usage
nat‐bindings (Optional)SpecifiestheresettingofNATbindingrouterlimitstothe
defaultvalue.
nat‐cache (Optional)SpecifiestheresettingofNATcachesizerouterlimitstothe
defaultvalue.
nat‐dynami c ‐configs (Optional)SpecifiestheresettingthenumberofNATdynamicmapping
configurationstothedefaultvalue.
nat‐static‐config (Optional)Specifies
theresettingthenumberofNATstaticmapping
configurationstothedefaultvalue.
nat‐interface‐config (Optional)SpecifiestheresettingthenumberofconfiguredNATVLAN
interfacestothedefaultvalue.
nat‐global‐addr‐cfg (Optional)Specifiestheresettingthenumberconfigurableglobal
addressestothedefaultvalue.
nat‐global‐port‐cfg (Optional)Specifies
theresettingthenumberofconfigurableglobal
portstothedefaultvalue.
Note: Router limits can also be cleared in the following contexts:
To clear LSNAT router limits see clear router limits (LSNAT) on page 19-34.
To clear TWCB router limits see clear router limits (TWCB) on page 23-17.
If you do not specify a parameter when issuing a clear router limits command, router limits for all
contexts are reset to the default value.