Setting Flow Control set port flowcontrol
4-38 Port Configuration
Table 4‐4providesanexplana tion ofthecommandoutput.
set port flowcontrol
Usethiscommandtoenableordisableflowcontrolsettingsforoneormoreports.
Syntax
set port flowcontrol port-string {receive | send | both}{enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoenableportsfe.3.1through5tosendandreceiveflowcontrolpackets:
Matrix(rw)->set port flowcontrol fe.3.1-5 both enable
Table 4-4 show port flow control Output Details
Output... What it displays...
Port Port designation. For a detailed description of possible port-string
values, refer to “Port String Syntax Used in the CLI” on page 4-2.
TX Admin Whether or not the port is administratively enabled or disabled for
sending flow control frames.
TX Oper Whether or not the port is operationally enabled or disabled for
sending flow control frames.
RX Admin Whether or not the port is administratively enabled or disabled for
acknowledging received flow control frames.
RX Oper Whether or not the port is operationally enabled or disabled for
acknowledging received flow control frames.
TX Pause Count Number of Pause frames transmitted.
RX Pause Count Number of Pause frames received.
port‐string Specifiesport(s)forwhichtoenableordisableflowcontrol.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.
receive|send|both Enablesordisablestheport(s)toreceive,send,orreceiveandsendflow
controlpackets.
enable|disable Enablesordisablesflowcontrolsettings.
To Next Page
Loading...
Need help?
General