Enterasys Matrix DFE-Gold Series

Configuring Convergence End Points (CEP) Phone Detection set cep detection-id
25-44 Authentication Configuration
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Thisisthepolicythatwillbeappliedwhenaphoneofthespecifiedtypeisdetectedonaport.It
mustbeconfiguredusingthepolicymanagementcommandsdescribedinChapter 8.
Example
Thisexampleshowshowtoassignpolicyindex1:
Matrix>set cep policy h323 1 to all H.323 phones detected
set cep detection-id
UsethiscommandtocreateanewH.323,Siemens,orSIPphonedetectionconfigurationgroup,or
enable,disableorremoveanexistinggroup.
Syntax
set cep detection-id id {create | delete | disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
cisco SettheCiscoglobaldefaultpolicyindex.
h323 SettheH323globaldefaultpolicyindex.
siemens SettheSiemensglobaldefaultpolicyindex.
sip SettheSIPglobaldefaultpolicyindex.
index Setthepolicyindexvalue.Thismustbeconfiguredusingthepolicy
managementcommandsdescribedinChapter 8. Validvalues
are1‐
65535.
id SpecifiesaCEPconfigurationgroupvalue.Validvaluesare1‐
2147483647.
create|delete|
disable|enable
Createsanewconvergenceendpointsdetectionconfigurationgroup,
orremoves,disablesorenablesanexistinggroup.Agroupmustfirstbe
createdthenenabledtobecomeoperational.