Enterasys Matrix DFE-Gold Series

clear vlan interface Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
Enterasys Matrix DFE-Gold Series Configuration Guide 7-13
clear vlan interface
UsethiscommandtocleartheMIB‐IIinterfaceentrymappedtoaVLAN.
Syntax
clear vlan interface vlan-list
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtocleartheinterfaceentrymappedtoVLAN1:
Matrix(rw)->clear vlan interface 1
show port ingress filter
Usethiscommandtoshowallportsthatareenabledforportingressfiltering, whichlimits
incomingVLANIDframesaccordingtoaportVLANegresslist.
Syntax
show port ingress-filter [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,ingressfilteringstatusforallportswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Usage
IftheVLANIDspecifiedinthereceivedframeisnotontheport’sVLANegresslist,thenthat
frameisdroppedandnotforwarded.
vlan‐list SpecifiestheVLAN(s)forwhichaninterfaceentrywillbecleared.
port‐string (Optional)Specifiestheport(s)forwhichtodisplayingressfiltering
status.Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage 4‐2.