Enterasys Matrix DFE-Gold Series User Manual

show port ratelimit Configuring Port Traffic Rate Limiting
Enterasys Matrix DFE-Gold Series Configuration Guide 22-9
Configuring Port Traffic Rate Limiting
Purpose
TolimittherateofinboundtrafficontheEnterasysMatrixSeriesdeviceonaperport/priority
basis.Theallowablerangefortheratelimitingis125kilobytespersecondminimumuptothe
maximumtransmissionrateallowableontheinterfacetype.
Ratelimitisconfiguredforagivenportand
listofpriorities.Thelistofprioritiescanincludeone,
some,oralloftheeight802.1pprioritylevels.Onceconfigured,therateofalltrafficenteringor
leavingtheportwiththeprioritiesconfiguredtothatportisnotallowedtoexceedthe
programmedlimit.Iftherateexceedsthe
programmedlimit,framesaredroppeduntiltherate
fallsbelowthelimit.
Commands
show port ratelimit
Usethiscommandtoshowthetrafficratelimitingconfigurationononeormoreports.
Syntax
show port ratelimit [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,ratelimitinginformationwillbedisplayedforallports.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythecurrentratelimitinginformationforfe.2.1:
Matrix(rw)->show port ratelimit fe.2.1
Global Ratelimiting status is disabled.
Port Threshold Priority
Number Index (kB/s) Action Direction List Status
For information about... Refer to page...
show port ratelimit 22-9
set port ratelimit 22-10
clear port ratelimit 22-11
port‐string (Optional)Displaysrate limitinginformationforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English