Enterasys Matrix DFE-Gold Series

set port enable Disabling / Enabling and Naming Ports
Enterasys Matrix DFE-Gold Series Configuration Guide 4-21
set port enable
Usethiscommandtoadministrativelyenableoneormoreports.
Syntax
set port enable port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoenableFastEthernetport3inmodule1:
Matrix(rw)->set port enable fe.1.3
show port alias
Usethiscommandtodisplayaliasname(sassignedtooneormoreports.
Syntax
show port alias [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,aliasesforallportswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplayaliasinformation forfe.3.1.Inthiscase,analiashas notbeen
assigned:
Matrix(rw)->show port alias fe.3.1
Alias not assigned on port fe.3.1.
port-string
Specifiestheport(s)toenable.Foradetaileddescriptionofpossible
port‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page 4‐2.
port-string
(Optional)Displaysaliasname(s)forspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.