Enterasys Matrix DFE-Gold Series User Manual

redistribute Configuring OSPF
Enterasys Matrix DFE-Gold Series Configuration Guide 21-21
OSPF Configuration Task List and Commands
Table 21‐2liststhetasksandcommandsassociatedwithOSPFconfiguration.Commandsare
describedintheassociatedsectionasshown.
.
Note: Activating your advanced routing license, and enabling OSPF with the router ospf and
network commands are required if you want to run OSPF on the device. All other tasks are
optional.
Table 21-2 OSPF Configuration Task List and Commands
To do this... Use these commands...
If necessary, activate your advanced routing
license.
set license (“set license” on page 2-58)
Enable OSPF configuration mode, associate a
network and assign a router ID.
router ospf (“router ospf” on page 21-22)
network (“network” on page 21-23)
router id (“router id” on page 21-24)
Configure OSPF Interface Parameters.
Set the cost of sending a packet on an OSPF
interface.
ip ospf cost (“ip ospf cost” on page 21-24)
Set a priority to help determine the OSPF
designated router for the network.
ip ospf priority (“ip ospf priority” on page 21-25)
Adjust timers and message intervals. timers spf (“timers spf” on page 21-26)
ip ospf retransmit-interval (“ip ospf retransmit-interval” on
page 21-26)
ip ospf transmit-delay (“ip ospf transmit-delay” on
page 21-27)
ip ospf hello-interval (“ip ospf hello-interval” on
page 21-28)
ip ospf dead-interval (“ip ospf dead-interval” on
page 21-28)
Configure OSPF authentication. ip ospf authentication-key (“ip ospf authentication-key” on
page 21-29)
ip ospf message digest key md5 (“ip ospf message digest
key md5” on page 21-30)
Configure OSPF Areas.
Configure an administrative distance. distance ospf (“distance ospf” on page 21-30)
Define the range of addresses to be used by
Area Boundary Routers (ABRs).
area range (“area range” on page 21-31)
Enable area authentication. area authentication (“area authentication” on page 21-32)
Define an area as a stub area. area stub (“area stub” on page 21-33)
Set the cost value for the default route that is
sent into a stub area.
area default cost (“area default cost” on page 21-34)
Define an area as an NSSA. area nssa (“area nssa” on page 21-34)
Create virtual links. area virtual-link (“area virtual-link” on page 21-35)

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English