Enterasys Matrix DFE-Gold Series

Configuring Network Address Translation (NAT) clear ip nat translation
18-12 Network Address Translation (NAT) Configuration
access-list 35 refcount 28
pool vlan 3000: netmask 0.0.0.0
start 85.1.1.1 end 85.1.1.1
type napt, total addresses 1, allocated 1, max_ports 32000, used_ports 28 (0%)
,
misses 0
clear ip nat translation
UsethiscommandtoclearactivedynamicNATtranslations.
Syntax
clear ip nat translation
Parameters
None.
Defaults
None.
Mode
Routercommand,Globalconfiguration:Matrix‐>Router(config)#
Example
ThisexampleclearsdynamicipNATtranslationsforthisrouter:
Matrix->Router(config)#clear ip nat translation
clear ip nat translation inside (NAT)
UsethiscommandtoclearanactivesimpleNATtranslation.
Syntax
clear ip nat translation inside global-ip local-ip
Parameters
Defaults
None.
Mode
Routercommand,Globalconfiguration:Matrix‐>Router(config)#
global‐ip Specif iestheuniquepublicIPaddresstoclearforthisstaticsimple
translation.
local‐ip SpecifiestheprivateIPaddresstoclearforthisstaticsimpletranslation.