Enterasys Matrix DFE-Gold Series

Configuring System Logging set logging server
10-4 System Logging Configuration
Defaults
Ifindexisnotspecified,allSyslogserverinformationwillbedisplayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaySyslogserverconfigurationinformation.Foranexplanation
ofthecommandoutput,referbacktoTable 10‐1.
Matrix(rw)->show logging server
IP Address Facility Severity Description Port Status
-------------------------------------------------------------------------
1 132.140.82.111 local4 warning(5) default 514 enabled
2 132.140.90.84 local4 warning(5) default 514 enabled
set logging server
UsethiscommandtoconfigureaSyslogserver.
Syntax
set logging server index [ ip-addr ip-addr] [facility facility] [severity severity]
[descr descr] [port port] [state {enable | disable}]
Parameters
index Specifiestheservertableindexnumberforthisserver.Validvaluesare
1‐8.
ip‐addrip‐addr (Optional)SpecifiestheSyslogmessageserver’sIPaddress.
facilityfacility (Optional)Specifiestheserver’sfacilityname.Validvaluesare:local0to
local7.
severityseverity (Optional)Specifiestheseveritylevelatwhichtheserverwill
log
messages.Validvaluesandcorrespondinglevelsare:
1 - emergencies (system is unusable)
2 - alerts (immediate action required)
3 - critical conditions
4 - error conditions
5 - warning conditions
6 - notifications (significant conditions)
7 - informational messages
8 - debugging messages
descrdescr (Optional)Specifiesatextualstringdescriptionofthisfacility/server.
portport (Optional)SpecifiesthedefaultUDPporttheclientusestosendtothe
server.
stateenable|disable (Optional)Enablesordisablesthisfacility/serverconfiguration.