Enterasys Matrix DFE-Gold Series User Manual

Enterasys Matrix DFE-Gold Series Configuration Guide 4-1
4
Port Configuration
ThischapterdescribesthePortConfigurationsetofcommandsandhowtousethem.
Port Configuration Summary
Console Port(s)
EachMatrixSeriesmoduleorstandalonedeviceincludesaconsoleportthroughwhichlocal
managementofthedevicecanbeaccessedusingaterminalormodem.
Fordetailsonconfiguringoneormoreconsoleportsettings,referto“SettingConsolePort
Properties”onpage 4‐3.
Formoduleplacementrulesand
considerationsforconfiguringlocalmanagementonDFE‐Gold
modules,refertotheMatrixDFE‐GoldSeriesInstallationGuide.
FordetailsonactivatingredundancyonaDFE‐GoldSeriesmodule,referto“ActivatingLicensed
Features”onpage 2 ‐58.
Important Notice
CLI examples in this guide illustrate a generic Matrix command prompt and chassis-based / modular port
designations. Depending on which Matrix Series device you are using, your default command prompt and
output may be different than the examples shown.
For information about... Refer to page...
Port Configuration Summary 4-1
Setting Console Port Properties 4-3
Reviewing Port Status 4-13
Disabling / Enabling and Naming Ports 4-20
Setting Speed and Duplex Mode 4-24
Enabling / Disabling Jumbo Frame Support 4-27
Setting Auto-Negotiation and Advertised Ability 4-30
Setting Flow Control 4-37
Configuring Link Traps and Link Flap Detection 4-39
Configuring Broadcast Suppression 4-49
Configuring Port Mirroring 4-52
Configuring LACP 4-55

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English