Enterasys Matrix DFE-Gold Series

set spantree bridgehellomode Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-23
Example
ThisexampleshowshowtodisplaytheSpanningTreebridgehellomode.Inthiscase,asingle
bridgehellomodehasbeenenabledusingthesetspantreebridgehellomodecommandas
describedin“setspantreehello”onpage 6‐24:
Matrix(rw)->show spantree bridgehellomode
Bridge Hello Mode is currently enabled.
set spantree bridgehellomode
Usethiscommandtoenableordisablebridgehellomodeonthedevice.
Syntax
set spantree bridgehellomode {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtodisablesingleSpanningTreehellomodeonthedevice.Per‐porthello
timescannowbeconfiguredusingthesetspantreeporthellomodecommandasdescribedin“set
spantreeporthello”onpage 6‐56:
Matrix(rw)->set spantree bridgehellomode disable
clear spantree bridgehellomode
UsethiscommandtoresettheSpanningTreeadministrativehellomodetoenabled.
Syntax
clear spantree bridgehellomode
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
enable EnablessingleSpanningTreebridgehellomode.
disable DisablessingleSpanningTreebridgehellomode,allowingforthe
configurationofper‐porthellotimes.