To Next Page

To Previous Page

Configuring Policy Class of Service (CoS) clear cos port-config txq

8-30 Policy Classification Configuration

Parameters

Defaults

•Ifanameisnotspecified,defaultnamesdescribedinTable 8‐5willbeapplied.

•Ifnotspecified,thisconfigurationwillbeappliedtoallportsintheportgroup.

•Ifappendorcleararenotspecified,port(s)willbeappendedtothespecifiedportgrouping.

•Ifarb‐sliceorarb‐percentage

valuesarenotspecified,defaultallocationswillbeapplied.

Mode

Switchcommand,Read‐Write.

Example

ThisexampleshowshowtocreateaCoStransmitqueueportgroupentrynamed“testtxq”witha

portgroupIDof2andaporttypeIDof1:

Matrix(rw)->set cos port-config txq 2.1 name test txq

clear cos port-config txq

Usethiscommandtoclearoneorallnon‐defaultClassofServicetransmitqueueportgroup

configurations:

Syntax

clear cos port-config txq all | group-type-index {entry | name | ports }

Parameters

Defaults

None.

group‐type‐index Specifiesatransmitqueueportgroup/typeindexforthisentry.Valid

entriesareintheformofgroup.type.Groupcanbe0‐7,with0

designatingthedefaultgroup,and1‐7reservedforuser‐defined

groups.Defaultporttypevaluescannotbechanged,andare0

forthe

7GR4270‐12,7G4270‐12,7G4270‐09,and7 G4270‐10DFEmodulesonly,

and1forallothermodules.

namename (Optional)Specifiesanameforthisconfiguration.

portsport‐list (Optional)Appliesthisconfigurationtooneormoreportsintheport

group.

append|clear (Optional)Appendsorclearsport

designationsfromapreviously

configuredportgroup.

all|group‐type‐index Clearsalltransmitqueueportconfigentriesoraspecificentry.

entry Clearsallnon‐defaulttransmitqueueentries.

name Clearsthenameassociatedwiththistransmitqueueentry.

ports Clearstheport(s)assignedtothisportgroup.

Enterasys Matrix DFE-Gold Series User Manual

Questions and Answers: