Enterasys Matrix DFE-Gold Series

set spantree adminpoint Configuring Spanning Tree Port Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-63
Defaults
Ifnotspecified,statuswillbedisplayedforallports.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythepoint‐to‐pointstatus operatingoftheLANsegment
attachedtofe.2.7:
Matrix(rw)->show spantree operpoint port fe.2.7
Port fe.2.7 has a Port Oper Point to Point of False on SID 1
set spantree adminpoint
Usethiscommandtosettheadministrativepoint‐to‐pointstatusoftheLANsegmentattachedto
aSpanningTreeport.
Syntax
set spantree adminpoint port-string {true | false | auto}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosettheLANattachedtofe.1.3asapoint‐to‐pointsegment:
Matrix(rw)->set spantree adminpoint fe.1.3 true
port‐string Specifiestheportonwhichtosetpoint‐to‐pointprotocolstatus.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.
true|false|auto Specifiesthepoint‐to‐pointstatusoftheLANattachedto
thespecified
port.
• trueforcestheporttobeconsideredpoint‐to‐point.
• falseforcestheporttobeconsiderednonpoint‐to‐point.
• auto(thedefaultsetting)allowsthefirmwaretodeterminethe
port’spoint‐to‐pointstatus.