Enterasys Matrix DFE-Gold Series

clear spantree lptrapenable Configuring Spanning Tree Loop Protect Features
Enterasys Matrix DFE-Gold Series Configuration Guide 6-75
Example
ThisexampleshowshowtodisplaythecurrentLoopProtecteventnotificationstatus:
Matrix(rw)->show spantree lptrapenable
LoopProtect event traps are enabled
clear spantree lptrapenable
UsethiscommandtoreturntheLoopProtecteventnotificationstatetoitsdefaultstateof
disabled.
Syntax
clear spantree lptrapenable
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoresettheLoopProtecteventnotificationstatetothedefaultof
disabled
Matrix(rw)->clear spantree lptrapenable
set spantree disputedbpduthreshold
UsethiscommandtosetthedisputedBPDUthreshold,whichisthenumberofdisputedBPDUs
thatmustbereceivedonagivenport/SIDuntiladisputedBPDUtrapissent.
Syntax
set spantree disputedbpduthreshold value
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
value SpecifiesthenumberofdisputedBPDUsthatmustbereceivedona
givenport/SIDtocauseadisputedBPDUtraptobesent.
A threshold of 0 indicates that traps should not be sent. The default
value is 0.