Enterasys Matrix DFE-Gold Series

show igmp protocols Configuring IGMP
Enterasys Matrix DFE-Gold Series Configuration Guide 9-13
show igmp protocols
UsethiscommandtodisplaythebindingofIPprotocolidtoIGMPclassification.
Syntax
show igmp protocols
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaythebindingofIPprotocolidtoIGMPclassification:
Matrix(rw)->show igmp protocols
Protocol Classifications
Protocol Ids set to Mcast Data
17
Protocol Ids set to routing Protocol
3,7-9,42-43,45,47-48,85-86,88-89,91-92,100,103,112
Protocol Ids set to Ignore
0,4-6,10-16,18-41,44,46,49-84,87,90,93-99,101-102,104-111,113-255
set igmp protocols
UsethiscommandtochangestheIGMPclassificationofreceivedIPframes
Syntax
set igmp protocols [classification classification] [protocol-id protocol-id]
[modify]
Parameters
classification
classification
Specifiestheclassification.Optionsare:
• 1-multicast data
• 2-routing protocol
• 3-ignore
protocol‐idprotocol‐id Theprotocolidstochange(0‐255).
modify Addtoexistingclassifications.Ifnotused,protocolswillbe
overwritten.