Enterasys Matrix DFE-Gold Series

Enterasys Matrix DFE-Gold Series Configuration Guide 12-1
12
Network Address and Route Management
Configuration
Thischapterdescribesswitch‐relatednetworkaddressandroutemanagementcommandsand
howtousethem.
Managing Switch Network Addresses and Routes
Purpose
Todisplay,addordeleteswitchARPtableentries,toenableordisableRAD(RuntimeAddress
Discovery)protocol,todisplay,addordeleteIProutingtableaddresses,andtodisplayMAC
addressinformation.
Commands
Note: The commands in this section pertain to the Enterasys Matrix Series device from the switch
CLI only. For information on router-related network management tasks, including reviewing router
ARP tables and IP traffic, refer to Chapter 16.
For information about... Refer to page...
show arp 12-2
set arp 12-3
clear arp 12-3
show rad 12-4
set rad 12-4
show ip route 12-5
traceroute 12-6
set ip route 12-8
clear ip route 12-8
show port mac 12-9
show mac 12-10
set mac 12-11
clear mac 12-12