Enterasys Matrix DFE-Gold Series

Starting and Configuring Telnet show telnet
2-76 Startup and General Configuration
Starting and Configuring Telnet
Purpose
ToenableordisableTelnet,andtostartaTelnetsessiontoaremotehost.TheMatrixSeriesdevice
allowsatotaloffourinboundand/oroutboundTelnetsessiontorunsimultaneously.
Commands
Thecommandsusedtoenable,startandconfigureTelnetarelistedbelowanddescribedinthe
associatedsectionasshown.
show telnet
UsethiscommandtodisplaythestatusofTelnetonthedevice.
Syntax
show telnet
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplayTelnet:
Matrix(rw)->show telnet status
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
For information about... Refer to page...
show telnet 2-76
set telnet 2-77
telnet 2-77
show router telnet 2-78
set router telnet 2-78
clear router telnet 2-79