Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Bridge Parameters clear spantree txholdcount
6-34 Spanning Tree Configuration
Example
Thisexampleshowshowtogloballysetthetransmitholdcountto5:
Matrix(rw)->set spantree txholdcount 5
clear spantree txholdcount
Usethiscommandtoresetthetransmitholdcounttothedefaultvalueof6.
Syntax
clear spantree txholdcount
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthetransmithold count:
Matrix(rw)->clear spantree txholdcount
show spantree maxhops
UsethiscommandtodisplaytheSpanningTreemaximumhopcount.
Syntax
show spantree maxhops
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheSpanningTreemaximumhopcount:
Matrix(rw)->show spantree maxhops
Bridge Max Hop count is set to 20