Enterasys Matrix DFE-Gold Series User Manual

Enterasys Matrix DFE-Gold Series Configuration Guide 21-1
21
Routing Protocol Configuration
ThischapterdescribestheRoutingProtocolConfigurationsetofcommandsandhowtousethem.
Activating Advanced Routing Features
Inordertoenableadvancedroutingprotocols,suchasOSPFandextendedACLs,onanEnterasys
MatrixSeriesdevice,youmustpurchaseandactivatealicens ekey.Ifyouhavepurchasedan
advancedroutinglicense,andhaveenabledroutingonthedeviceasdescribedinprevious
chapters,youcanactivateyour
licenseasdescribedin“ActivatingLicensedFeatures”on
page 2‐58.Ifyouwishtopurchaseanadvancedroutinglicense,contactEnterasysNetworksSales.
Configuring RIP
Purpose
Toenableandconfigurethe RoutingInformationProtocol(RIP).
RIP Configuration Task List and Commands
Table 21‐1liststhetasksandcommandsassociatedwithRIPconfiguration.Commandsare
describedintheassociatedsectionasshown.
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to “Enabling Router
Configuration Modes” on page 2-103.
For information about... Refer to page...
Activating Advanced Routing Features 21-1
Configuring RIP 21-1
Configuring OSPF 21-19
Configuring DVMRP 21-52
Configuring IRDP 21-55
Configuring VRRP 21-61
Note: Enabling RIP with the router rip and network commands is required if you want to run RIP
on the device. All other tasks are optional.

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English