Enterasys Matrix DFE-Gold Series User Manual

Link Layer Discovery Protocol and LLDP-MED clear ciscodp
3-16 Discovery Protocols Configuration
Commands
Step Task
Command(s)
1. Configure global system LLDP parameters set lldp tx-interval
set lldp hold-multiplier
set lldp trap-interval
set lldp med-fast-repeat
clear lldp
2. Enable/disable specific ports to:
• Transmit and process received LLDPDUs
• Send LLDP traps
• Send LLDP-MED traps
set/clear lldp port status
set/clear lldp port trap
set/clear lldp port med-trap
3. Configure an ECS ELIN value for specific ports set/clear lldp port location-info
4. Configure Network Policy TLVs for specific ports set/clear lldp port network-policy
5. Configure which optional TLVs should be sent by
specific ports. For example, if you configured an
ECS ELIN and/or Network Policy TLVs, you must
enable those optional TLVs to be transmitted on
the specific ports.
set/clear lldp tx-tlv
For information about... Refer to page...
show lldp 3-17
show lldp port status 3-18
show lldp port trap 3-18
show lldp port tx-tlv 3-19
show lldp port location-info 3-20
show lldp port local-info 3-20
show lldp port remote-info 3-23
show lldp port network-policy 3-24
set lldp tx-interval 3-26
set lldp hold-multiplier 3-26
set lldp trap-interval 3-27
set lldp med-fast-repeat 3-27
set lldp port status 3-28
set lldp port trap 3-29
set lldp port med-trap 3-29
set lldp port location-info 3-30
set lldp port tx-tlv 3-30
set lldp port network-policy 3-32

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English