Enterasys Matrix DFE-Gold Series User Manual

Startup and General Configuration Summary
2-6 Startup and General Configuration
CLI “Defaults” Descriptions
Eachcommanddescriptioninthisguideincludesasectionentitled“Defaults”whichcontains
differentinformationthanthefactorydefaultsettingsonthedeviceasdescribedinTable 2‐1and
Table 2‐2.ThecommanddefaultssectiondefinesCLIbehavioriftheuserentersacommand
withouttypingoptionalparameters(indicatedby
squarebrackets[]).Forcommandswithout
optionalparameters,thedefaultssectionlists“None”.Forcommandswithoptionalparameters,
thissectiondescribeshowtheCLIrespondsiftheuseroptstoenteronlythekeywordsofthe
commandsyntax.
CLI Command Modes
Eachcommanddescriptioninthisguideincludesasectionentitled“CommandMode”which
stateswhetherthecommandisexecutableinAdmin(SuperUser),Read‐WriteorRead‐Only
mode.UserswithRead‐OnlyaccesswillonlybepermittedtoviewRead‐Only(show)commands.
UserswithRead‐Writeaccesswill
beabletomodifyallmodifiableparametersinsetandshow
commands,aswellasviewRead‐Onlycommands.AdministratorsorSuperUserswillbeallowed
allRead‐WriteandRead‐Onlyprivileges,andwillbeabletomodifylocaluseraccounts.The
MatrixSeriesdeviceindicateswhichmodea
userisloggedinasbydisplayingoneofthe
followingprompts:
•Admin:Matrix(su)‐>
•Read‐Write:Matrix(rw)‐>
•Read‐Only:Matrix(ro)‐>
OSPF priority Set to 1.
Passive interfaces (RIP) None configured.
Proxy ARP Enabled on all interfaces.
Receive interfaces (RIP) Enabled on all interfaces.
Retransmit delay (OSPF) Set to 1 second.
Retransmit interval (OSPF) Set to 5 seconds.
RIP receive version Set to accept both version 1 and version 2.
RIP send version Set to version 1.
RIP offset No value applied.
SNMP Enabled.
Split horizon Enabled for RIP packets without poison reverse.
Stub area (OSPF) None configured.
Telnet Enabled.
Telnet port (IP) Set to port number 23.
Timers (OSPF) SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Transmit delay (OSPF) Set to 1 second.
VRRP Disabled.
Table 2-2 Default Device Settings for Router Mode Operation (continued)
Device Feature Default Setting

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English