Enterasys Matrix DFE-Gold Series User Manual

show system hardware Setting Basic Device Properties
Enterasys Matrix DFE-Gold Series Configuration Guide 2-35
Temp-Alarm Uptime d,h:m:s Logout
------------- -------------- -------------
off 0,19:40:00 10 min
PS1-Type PS2-Type
------------- -------------
6C207-1 not installed
Table 2‐5providesanexplana tion ofthecommandoutput.
show system hardware
Usethiscommandtodisplaythesystem’shardwareconfiguration.
Syntax
show system hardware
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Table 2-5 Show System Output Display
Output... What it displays...
System contact Contact person for the system. Default of a blank string can be
changed with the set system contact command (“set system contact”
on page 2-51).
System location Where the system is located. Default of a blank string can be changed
with the set system location command (“set system location” on
page 2-50).
System name Name identifying the system. Default of a blank string can be changed
with the set system name command (“set system name” on
page 2-50).
PS1 and PS2-Status Operational status for power supply 1 and, if installed, power supply 2.
Fan Status Operational status of the fan tray.
Temp-Alarm Whether or not the system temperature alarm is off (within normal
temperature range) or on.
Uptime d,h:m:s System uptime.
Logout Time an idle console or Telnet CLI session will remain connected
before timing out. Default of 15 minutes can be changed with the set
logout command (“set logout” on page 2-53).
PS1 and PS2-Type Model number of power supply 1 and, if installed, power supply 2.

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English