Enterasys Matrix DFE-Gold Series

Managing Router Configuration Files show running-config
16-8 IP Configuration
Managing Router Configuration Files
EachEnterasysMatrixSeriesdeviceprovidesasingleconfigurationinterfacewhichallowsyouto
performbothswitchandrouterconfigurationwiththesamecommandset.Whenaredundancy
licenseisavailableandhasbeenactivated,thedevicealsoprovidesredundant,distributedcopies
ofeachrouterconfigurationintheeventthatDFE
modulesareaddedorremovedfromthe
EnterasysMatrixchassis.Thissectiondemonstratesmanagingconfigurationfileswhileoperating
inroutermodeonly.Forasampleofhowtousethesecommandsinterchangeablywiththe
EnterasysMatrixSeriessingleconfigurationinterfacecommands,referto“PerformingaBasic
RouterConfiguration”on
page 16‐11.
Purpose
Toreviewandsavethecurrentrouterconfiguration,andtodisableIProuting.
Commands
show running-config
Usethiscommandtodisplaythenon‐default,user‐suppliedcommandsenteredwhileconfiguring
thedevice.
Syntax
show running-config
Parameters
None.
Defaults
None.
Mode
Routercommand,Anyroutermode.
Example
Thisexampleshowshowtodisplaythecurrentrouteroperatingconfiguration:
Matrix>Router#show running-config
!
router id 192.168.100.1
!
interface loopback 1
For information about... Refer to page...
show running-config 16-8
write 16-9
no ip routing 16-10