To Next Page

To Previous Page

Configuring Node Aliases set nodealias

14-6 Node Alias Configuration

Defaults

Ifport‐stringisnotspecified,nodealiasconfigurationswillbedisplayedforallports.

Mode

Switchcommand,Read‐Only.

Example

Thisexampleshowshowtodisplaynodealiasconfigurationsettingsforportsfe.2.1through9:

Matrix(rw)->show nodealias config fe.2.1-9

Port Number Max Entries Used Entries Status

----------- ----------- ------------ ------

fe.2.1 16 0 Enabled

fe.2.2 47 0 Enabled

fe.2.3 47 2 Enabled

fe.2.4 47 0 Enabled

fe.2.5 47 0 Enabled

fe.2.6 47 2 Enabled

fe.2.7 47 0 Enabled

fe.2.8 47 0 Enabled

fe.2.9 4000 1 Enabled

Table 14‐2providesanexplanationofthecommandoutput.

set nodealias

Usethiscommandtoenableordisableanodealiasagentononeormoreports.

Syntax

set nodealias {enable | disable} port-string

Parameters

Table 14-2 show nodealias config Output Details

Output... What it displays...

Port Number Port designation.

Max Entries Maximum number of alias entries configured for this port. Set using the

set nodealias maxentries command (“set nodealias maxentries” on

page 14-7).

Used Entries Number of alias entries (out of the maximum amount configured)

already used by this port.

Status Whether or not a node alias agent is enabled (default) or disabled on

this port.

enable|disable Enablesordisablesanodealiasagent.

port‐string Specifiestheport(s)onwhichtoenableordisableanodealiasagent.

Foradetaileddescriptionofpossibleport‐stringvalues,referto“Port

StringSyntaxUsedintheCLI”onpage 4‐2.

Enterasys Matrix DFE-Gold Series User Manual

Questions and Answers: