Enterasys Matrix DFE-Gold Series

Configuring Multiple Authentication clear multiauth session-timeout
27-14 MultiAuth Configuration
clear multiauth session-timeout
Usethiscommandtoclearsession‐timeoutvalues,foroneorallauthenticationmethods,backto
thedefaultvalues.
Syntax
clear multiauth session-timeout [cep | dot1x | mac | pwa]
Parameters
Defaults
Ifnoauthenticationtypeisspecified,thesessiontimeoutvalueisreturnedto300secondsforall
authenticationtypes.
Mode
Switchcommand,Read‐Write.
Examples
Thisexampleshowshowtoclearthesession‐timeoutvalues,foranactivesession,forcepandmac
authenticationtypes,tothedefaultvalueof0seconds:
Matrix(rw)->clear multiauth idle-timeout cep
Matrix(rw)->clear multiauth idle-timeout mac
Thisexampleshowshowtoclearthesession‐timeoutvalues,foranactivesession,forall
authenticationtypes,tothedefaultvalueof0seconds:
Matrix(rw)->set multiauth idle-timeout
set multiauth trap
Usethiscommandtosetthemultiauthtrapsettingfor system,moduleandport.
Syntax
set multiauth trap {system {enabled | disabled} | module {enabled | disabled} |
port portstring {all | success | failed | terminated | max-reached}}
cep (Optional)SpecifiestheauthenticationtypeEnterasysConvergence
EndPointAuthentication.
dot1x (Optional)SpecifiestheauthenticationtypeIEEE802.1XPort‐Based
NetworkAccessControl.
mac (Optional)SpecifiestheauthenticationtypeEnterasysMac
Authentication.
pwa (Optional)SpecifiestheauthenticationtypeEnterasysPortWeb
Authentication.