Enterasys Matrix DFE-Gold Series

Enterasys Matrix DFE-Gold Series Configuration Guide 3-1
3
Discovery Protocols Configuration
Thischapterdescribeshowtoconfigurethediscoveryprotocolssupportedbythefirmwareusing
CLIcommands.
Displaying Neighbors
Purpose
Theshowneighborscommanddisplaysneighbordiscoveredbyallsupportdiscoveryprotocols.
Command
show neighbors
UsethiscommandtodisplayNetworkNeighborDiscoveryinformationfromallsupported
discoveryprotcols.
Syntax
show neighbors [port-string]
Parameters
For information about... Refer to page...
Displaying Neighbors 3-1
Enterasys Discovery Protocol 3-3
Cisco Discovery Protocol 3-8
Link Layer Discovery Protocol and LLDP-MED 3-15
For information about... Refer to page...
show neighbors 3-1
port‐string (Optional)DisplaysNetworkNeighborDiscoveryinformationfora
specificport.Foradetaileddescriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsedintheCLI”onpage 4‐2.