Enterasys Matrix DFE-Gold Series

Assigning Port VLAN IDs (PVIDs) and Ingress Filtering set vlan interface
7-12 802.1Q VLAN Configuration
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheinterfaceentryforVLAN1:
Matrix(rw)->show vlan interface 1
VLAN Port Storage Type
-------------------------------------
1 vlan.0.1 non-volatile
Table 7‐3providesanexplana tion ofthecommandoutput.
set vlan interface
Usethiscommandtocreate,disableorenablesaMIB‐IIinterfacemappedtoaVLAN.
Syntax
set vlan interface vlan-list {create | disable | enable} [volatile]
Parameters
Defaults
Ifvolatileisnotspecified,entries willbecreatedasnonvolatile.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtocreateavolatileinterfaceentrymappedtoVLAN1:
Matrix(rw)->set vlan interface 1 volatile
Table 7-3 show vlan interface Output Details
Output... What it displays...
VLAN VLAN ID.
Port Port-string designation.
Storage Type Whether the entry is stored as a volatile or non-volatile entry. Volatile
entries are lost when a system is reset. Non-volatile entries are saved
in NVRAM and are persistent until cleared.
vlan‐list SpecifiestheVLAN(s)forwhichaninterfaceentrywillbecreated,
disabledorenabled.
create|disable|
enable
Creates,disablesorenablesaninterfaceentry.
volatile (Optional)Whenthecreatekeywordisused,storestheentryasa
volatileentry.Volatileentriesarelostwhenasystemisreset.
Non‐
volatileentriesaresavedinNVRAMandarepersistentuntilcleared.