Enterasys Matrix DFE-Gold Series

clear snmp access Configuring SNMP Access Rights
Enterasys Matrix DFE-Gold Series Configuration Guide 5-21
•Ifwriteviewisnotspecified,nonewillbeapplied.
•Ifnotifyviewisnotspecified,nonewillbeapplied.
•Ifstoragetypeisnotspecified,entries willbestoredaspermanentandwillbeheldthrough
devicereboot.
Mode
Switchcommand,Read‐Write.
Examples
Thisexamplepermitsthe“powergroup”tomanageallMIBsviaSNMPv3:
Matrix(rw)->set snmp access powergroup security-model usm
Thisexamplegrantsthe“powergroup”SNMPv3managementaccessfromallroutermodules
whenoperatinginroutermode:
Matrix(rw)->set snmp access powergroup security-model usm context router prefix
clear snmp access
UsethiscommandtocleartheSNMPaccessentryofaspecificgroup,includingitssetSNMP
security‐model,andlevelofsecurity.
Syntax
clear snmp access groupname security-model {v1 | v2c | usm} [noauthentication |
authentication | privacy] [context context]
Parameters
Defaults
•Ifsecuritylevelisnotspecified,alllevelswillbecleared.
•Ifcontextisnotspecified,nonewillbeapplied.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoclearSN MPversion3accessforthe“mis‐group”viathe
authenticationprotocol:
Matrix(rw)->clear snmp access mis-group security-model usm authentication
groupname SpecifiesthenameoftheSNMPgroupforwhichtoclearaccess.
security‐modelv1|
v2c|usm
SpecifiesthesecuritymodeltobeclearedfortheSNMPaccessgroup.
noauthentication|
authentication|
privacy
(Optional)ClearsaspecificsecuritylevelfortheSNMPaccessgroup.
contextcontext (Optional)Clearsaspecific
contextfortheSNMPaccessgroup.Enter/‐
/toclearthedefaultcontext.