Link Layer Discovery Protocol and LLDP-MED set lldp port network-policy
3-32 Discovery Protocols Configuration
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleconfiguresthemanagementaddress,MEDcapability,MEDnetworkpolicy,and
MEDlocationidentificationTLVstobesentinLLDPDUsbyportge.1.1.
Matrix(rw)->set lldp port tx-tlv mgmt-addr med-cap med-pol med-loc ge.1.1
set lldp port network-policy
Usethiscommandtoconfigurenetworkpolicyforasetofapplicationsonaportorrangeofports.
Syntax
set lldp port network-policy {all | voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice | video-conferencing | streaming-video |
video-signaling} [state {enable | disable}] [ tag {tagged | untagged}]
[vid {vlan-id | dot1p}] [cos cos-value] [dscp dscp-value] port-string
Parameters
med‐poe LLDP‐MEDExtendedPowerviaMDITLV.Valuessentincludethe
PowerLimit(totalpowertheportiscapableofsourcingovera
maximumlengthcable)andthepowerpriorityconfiguredontheport.
OnlyvalidforPoE‐enabled ports.
port-string
Specifiestheportorrangeofportstobeaffected.
all Configuresallapplications.
voice Configuresthevoiceapplication.
voice‐signaling Configuresthevoicesignalingapplication.
This application will not be advertised if the voice application is
configured with the same parameters.
guest‐voice Configurestheguestvoiceapplication.
guest‐voice‐signaling Configurestheguestvoicesignalingapplication.
This application will not be advertised if the guest-voice application is
configured with the same parameters.
softphone‐voice Configuresthesoftphonevoiceapplication.
video‐conferencing Configuresthevideoconferencingapplication.
streaming‐video Configuresthestreamingvideoapplication.
video‐signaling Configuresthevideosignalingapplication.
This application will not be advertised if the video-conferencing
application is configured with the same parameters.
To Next Page
Loading...
Need help?
General