Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Port Parameters clear spantree portpri
6-56 Spanning Tree Configuration
clear spantree portpri
UsethiscommandtoresetthebridgepriorityofaSpanningTreeporttoadefaultvalueof128.
Syntax
clear spantree portpri port-string [sid sid]
Parameters
Defaults
Ifsidisnotspecified,portprioritywillbesetforSpanningTree0.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthepriorityoffe.1.3to128onSID1:
Matrix(rw)->clear spantree portpri fe.1.3 sid 1:
set spantree porthello
UsethiscommandtosetthehellotimeforoneormoreSpanningTreeports.Thisisthetime
interval(inseconds)theport(s)willtransmitBPDUs.
Syntax
set spantree porthello port-string interval
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
port‐string Specifiestheport(s)forwhichtosetSpanningTreeportpriority.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.
sidsid (Optional)ResetstheportpriorityforaspecificSpanning Tree
identifier.Valid
valuesare0‐4094.Ifnotspecified,SID0willbe
assumed.
port‐string Specifiestheport(s)forwhichtosethellotime.
interval Specifiesthenumberofsecondsthesystemwaitsbeforebroadcastinga
bridgehellomessage.Validvaluesare1‐10.