To Next Page

To Previous Page

Configuring Multiple Authentication set multiauth mode

27-2 MultiAuth Configuration

Commands

set multiauth mode

Usethiscommandtosetthesystemauthenticationmodetousemultipleauthenticators

simultaneouslyortostrictlyadhereto802.1X.

Syntax

set multiauth mode {multi | strict}

Parameters

For information about... Refer to page...

set multiauth mode 27-2

clear multiauth mode 27-3

show multiauth 27-3

show multiauth counters 27-4

set multiauth precedence 27-5

clear multiauth precedence 27-5

show multiauth port 27-6

set multiauth port 27-6

clear multiauth port 27-7

show multiauth station 27-8

clear multiauth station 27-8

show multiauth session 27-9

show multiauth idle-timeout 27-10

set multiauth idle-timeout 27-10

clear multiauth idle-timeout 27-11

show multiauth session-timeout 27-12

set multiauth session-timeout 27-13

clear multiauth session-timeout 27-14

set multiauth trap 27-14

clear multiauth trap 27-15

show multiauth trap 27-16

multi Allowsthesystemtousemultipleauthenticatorssimultaneously.

Note: This mode requires that MAC, PWA, and 802.1X authentication be

enabled globally, and configured appropriately on the desired ports per its

corresponding command set as described in this chapter.

strict Setsthesystemauthenticationmodetostrict802.1X.

Enterasys Matrix DFE-Gold Series User Manual

Questions and Answers: