Enterasys Matrix DFE-Gold Series

set smon priority Configuring SMON
Enterasys Matrix DFE-Gold Series Configuration Guide 11-9
------------------------
Interface = ge.3.14
Owner = none
Creation = 0 days 0 hours 6 minutes 39 seconds
Status = enabled
--------------------
Priority 0 Packets Octets
----------
Total 7981308 2332402460
Overflow 0 0
set smon priority
Usethiscommandtocreate,start,orstoppriority‐encodedSMONuserstatisticscounting.
Syntax
set smon priority {create | enable | disable} port-string [owner]
Parameters
Defaults
Ifownerisnotspecified,nonewillbeapplied.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowsetthedevicetogatherSMONprioritystatisticsfrom1‐GigabitEthernet
port14inmodule3:
Matrix(rw)->set smon priority ge.3.14
clear smon priority
Clearspriority‐encodeduserstatisticsononeormoreports.
Syntax
clear smon priority [port-string]
create|enable|
disable
Creates,enables,ordisablesSMONprioritystatisticscounting.Create
automaticallyenables(starts)counters.
port‐string Specifiesoneormoresourceportsonwhichtocollectstatistics.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐
2.
owner (Optional)Specifiesanadministrativelyassignednameoftheownerof
thisentity.