Enterasys Matrix DFE-Gold Series

show cep policy Configuring Convergence End Points (CEP) Phone Detection
Enterasys Matrix DFE-Gold Series Configuration Guide 25-41
Parameters
Defaults
Ifnodetection‐idisspecified,allCEPdetectionparametersaredisplayed.
Mode
Read‐Only.
Examples
ThisexampleshowshowtodisplayCEPdetectioninformation:
Matrix>show cep detection
Global CEP state enabled
Detection Rules for Index 1:
Endpoint Phone Type h323
Protocol tcp & udp
Port Low 1718
Port High 1720
Address Type unknown
Address
Mask Type unknown
Mask
Row Status enabled
show cep policy
UsethiscommandtodisplaytheglobalpoliciesofallsupportedCEPtypes.
Syntax
show cep policy
Parameters
None.
Defaults
None
Mode
Read‐Only.
detection‐id (Optional)ShowCEPdetectionparameters,basedontheCEP
configurationgroupid.