Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Bridge Parameters clear spantree default
6-46 Spanning Tree Configuration
clear spantree default
UsethiscommandtorestoredefaultvaluestoaSpanningTree.
Syntax
clear spantree default [sid]
Parameters
Defaults
Ifsidisnotspecified,defaultswillberestoredonSpanningTree0.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtorestoreSpanningTreedefaultsonSID1:
Matrix(rw)->clear spantree default 1
show spantree debug
UsethiscommandtodisplaySpanningTreedebugcountersforoneormoreports.
Syntax
show spantree debug [port port-string] [sid sid] [active]
Parameters
Defaults
•Ifport‐stringisnotspecified,noportinformationwillbedisplayed.
•Ifsidisnotspecified,debugcounterswillbedisplayedforSpanningTree0.
Mode
Switchcommand,Read‐Only.
sid (Optional)RestoresdefaultsonaspecificSpanningTree.Validvalues
are0‐4094.Ifnotspecified,SID0isassumed.
portport‐string (Optional)Displaysdebugcountersforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
sidsid (Optional)DisplaysthedebugcountersforaspecificSpanningTree
identifier.Validvaluesare0‐4094.If
notspecified,SID0isassumed.
active (Optional)Displaysonlythedebugcountersforportsthathave
receivedatleastoneconfigurationorRSTPBPDU.