Enterasys Matrix DFE-Gold Series

Configuring SNMP Target Parameters show snmp targetparams
5-26 SNMP Configuration
Configuring SNMP Target Parameters
Purpose
ToreviewandconfigureSNMPtargetparameters.Thiscontrolswhereandunderwhat
circumstancesSNMPnotificationswillbesent.Atargetparameterentrycanbeboundtoatarget
IPaddressallowedtoreceiveSNMPnotificationmessageswiththesetsnmptargetaddr
command(“setsnmptargetaddr”onpage 5‐30)
Commands
show snmp targetparams
UsethiscommandtodisplaySNMPparametersusedtogenerate amessagetoatarget.
Syntax
show snmp targetparams [targetParams] [volatile | nonvolatile | read-only]
Parameters
Defaults
•IftargetParamsisnotspecified ,entriesassociatedwithalltargetparameterswillbedisplayed.
•Ifnotspecified,entriesofallstoragetypeswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaySNMPtargetparametersinformation:
Matrix(rw)->show snmp targetparams
--- SNMP TargetParams information ---
Target Parameter Name = v1ExampleParams
Security Name = public
Message Proc. Model = SNMPv1
Security Level = noAuthNoPriv
For information about... Refer to page...
show snmp targetparams 5-26
set snmp targetparams 5-27
clear snmp targetparams 5-28
targetParams (Optional)Displaysentriesforaspecifictargetparameter.
volatile|nonvolatile
|read‐only
(Optional)Displaystargetparameterentriesforaspecificstoragetype.