Enterasys Matrix DFE-Gold Series

Starting and Configuring Telnet show router telnet
2-78 Startup and General Configuration
Example
ThisexampleshowshowtostartaTelnetsessiontoahostat10.21.42.13:
Matrix(rw)->telnet 10.21.42.13
show router telnet
UsethiscommandtodisplaythestateofTelnetservicetotherouter.
Syntax
show router telnet
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaythestateofTelnetservicetotherouter:
Matrix(rw)->show router telnet
Telnet to Router IP is enabled
set router telnet
UsethiscommandtoenableordisableTelnetservicetotherouterinterfaceIPaddress.
Syntax
set router telnet {enable | disable}
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtodisableTelnetservicetothe router:
Matrix(rw)->set router telnet disable