Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Bridge Parameters clear spantree mstcfgid
6-18 Spanning Tree Configuration
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosettheMSTconfigurationnameto“mstconfig”:
Matrix(rw)->set spantree mstconfigid cfgname mstconfig
clear spantree mstcfgid
UsethiscommandtoresettheMSTrevisionleveltoadefaultvalueof0,andtheconfiguration
nametoadefaultstringrepresentingthebridgeMACaddress.
Syntax
clear spantree mstcfgid
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoresettheMSTconfigurationidentifierelementstodefaultvalues:
Matrix(rw)->clear spantree mstcfgid
show spantree bridgeprioritymode
UsethiscommandtodisplaytheSpanningTreebridgeprioritymodesetting.
Syntax
show spantree bridgeprioritymode
Parameters
None.
cfgnamename SpecifiesanMSTconfigurationname.
revlevel Specif iesanMSTrevisionlevel.Validvaluesare0‐65535.