Enterasys Matrix DFE-Gold Series

Configuring Multiple Authentication show multiauth idle-timeout
27-10 MultiAuth Configuration
Termination time: Not Terminated
show multiauth idle-timeout
Usethiscommandtodisplaythemultipleauthenticationtimeoutvalueforanidlesession.
Syntax
show multiauth idle-timeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Usage
Thiswilldisplaytheidle‐timeoutvalues,inseconds,forthefollowingauthenticationtypes:dot1x,
pwa,mac,andcep.
Example
Thisexampleshowshowtodisplaytimeoutvaluesforanidlesession,foreachofthe
authenticationtypes:
Matrix(rw)->show multiauth idle-timeout
Authentication type Timeout (sec)
------------------- -------------
dot1x 300
pwa 300
mac 300
cep 300
set multiauth idle-timeout
Usethiscommandtosetthemultiauthidle‐timeoutvalueperauthenticationmethodorforall
methods.
Syntax
set multiauth idle-timeout [cep | dot1x | mac | pwa] timeout
Parameters
cep (Optional)SpecifiestheauthenticationtypeEnterasysConvergence
EndPointAuthentication.
dot1x (Optional)SpecifiestheauthenticationtypeIEEE802.1XPort‐Based
NetworkAccessControl.