Enterasys Matrix DFE-Gold Series

set rmon stats Configuring RMON
Enterasys Matrix DFE-Gold Series Configuration Guide 11-17
set rmon stats
UsethiscommandtoconfigureanRMONstatisticsentry.
Syntax
set rmon stats index port-string [owner]
Parameters
Defaults
Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoconfigureRMONstatisticsentry2forfe.1.20:
Matrix(rw)->set rmon stats 2 fe.1.20
clear rmon stats
UsethiscommandtodeleteoneormoreRMONstatisticsentries.
Syntax
clear rmon stats {index-list | to-defaults}
Parameters
512 – 1023 Octets Total number of frames, including bad frames, received that were
between 512 and 1023 bytes in length (excluding framing bits, but
including FCS bytes).
1024 – 1518 Octets Total number of frames, including bad frames, received that were
between 1024 and 1518 bytes in length (excluding framing bits, but
including FCS bytes).
Table 11-3 show rmon stats Output Details (continued)
Output... What it displays...
index Specifiesanindexforthisstatisticsentry.
port‐string Specifiesport(s)towhichthisentrywillbeassigned.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
owner (Optional)Assignsanownerforthisentry.
index‐list Specifiesoneormorestatsentriestobedeleted,causingthemto
disappearfromanyfutureRM ONqueries.
to‐defaults Resetsallhistoryentriestodefaultvalues.Thiswillcauseentriesto
reappearinRMONqueries.