Enterasys Matrix DFE-Gold Series

Configuring PIM ip pim sparse mode
17-2 PIM Configuration
ip pim sparse mode
UsethiscommandtoenableProtocolIndependentMulticast(PIM)SparseMode(SM)ona
routinginterface.
Syntax
ip pim sparse-mode
no ip pim sparse-mode
Parameters
None.
Defaults
None.
Mode
Routercommand,Interfaceconfiguration:Matrix>Router(config‐if(Vlan1))#
Usage
The“no”formofthiscommanddisablesPIMonaninterface.
Example
ThisexampleenablesPIMsparsemodeonVLAN1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip pim sparse-mode
ip pim bsr-candidate
UsethiscommandtoenabletheroutertoannounceitscandidacyasaBootStrapRouter(BSR).
Syntax
ip pim bsr-candidate pim-interface [hash-mask-length] [priority]]
no ip bsr-candidate
show ip mforward 17-11
show ip rpf 17-12
For information about... Refer to page...