Enterasys Matrix DFE-Gold Series - Clear Flowlimit Port Class; Set Flowlimit Shutdown

Configuring Flow Setup Throttling (FST) clear flowlimit port class
24-32 Security Configuration
Defaults
Ifport‐stringisnotspecified,settingswillapplytoallports.
Mode
Switchcommand,Read‐Write.
Usage
Onceaclassificationisassigned,theseportswillbesubjecttotheflowlimitconfigured(withthe
setflowlimitlimitcommandasdescribedin“setflowlimitlimit”onpage 24‐27)andtheaction
configured(withthesetflowlimitactioncommandasdescribedin“setflowlimitaction”on
page 24‐28).
Example
ThisexampleshowshowtoassigntheuserportclassificationtypetoFastEthernetports3‐5in
module2:
Matrix(rw)->set flowlimit port class userport fe.2.3-5
clear flowlimit port class
Usethiscommandtoremoveflowlimitingportclassificationproperties.
Syntax
clear flowlimit port class [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,classificationswillberemovedfromallports.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoclearportclassificationsfromallGigabitEthernetports:
Matrix(rw)->clear flowlimit port class ge.*.*
set flowlimit shutdown
Usethiscommandtoenableordisabletheflowlimitshutdownfunction.
Syntax
set flowlimit shutdown {enable | disable}
port‐string (Optional)Specifiesport(s)onwhichtoremoveflowlimiting
classificationproperties.