Enterasys Matrix DFE-Gold Series

set lldp port trap Link Layer Discovery Protocol and LLDP-MED
Enterasys Matrix DFE-Gold Series Configuration Guide 3-29
set lldp port trap
UsethiscommandtoenableordisablesendingLLDPnotifications(traps)whenaremotesystem
changeisdetected.
Syntax
set lldp port trap {enable | disable} port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleenablestransmittingLLDPtrapsonportsge.1.1throughge.1.6.
Matrix(rw)->set lldp port trap enable ge.1.1-6
set lldp port med-trap
UsethiscommandtoenableordisablesendinganLLDP‐MEDnotificationwhenachangeinthe
topologyhasbeensensedontheport(thatis,aremoteendpointdevicehasbeenattachedor
removedfromtheport).
Syntax
set lldp port med-trap {enable | disable} port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
enable Enablestransmitti ngLLDPtraps onthespecifiedports.
disable DisablestransmittingLLDPtrapsonthespecifiedports.
port-string Specifiestheportorrangeofportstobeaffected.
enable EnabletransmittingLLDP‐MEDtrapsonthespecifiedports.
disable DisabletransmittingLLDP‐MEDtrapsonthespecifiedports.
port-string
Specifiestheportorrangeofportstobeaffected.