Enterasys Matrix DFE-Gold Series

Configuring RMON clear rmon event
11-26 Network Monitoring Configuration
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
AnRMONevententrycanbecreatedusing thiscommand,configuredusingthesetrmonevent
propertiescommand(“setrmoneventproperties”onpage 11‐25),thenenabledusingthis
command.AnRMONevententrycanbecreatedandconfiguredatthesametimebyspecifyingan
unusedindexwiththe
setpropertiescommand.
Example
ThisexampleshowshowtoenableRMONevententry1:
Matrix(rw)->set rmon event status 1 enable
clear rmon event
UsethiscommandtodeleteanRMONevententryandanyassociatedlogentries.
Syntax
clear rmon event index
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoclearRMONevent1:
Matrix(rw)->clear rmon event 1
index Specifiesanindexnumberforthisentry.Maximumnumberofentriesis
100.Maximumvalueis65535.
enable Enablesthisevententry.
index Specifiestheindexnumberoftheentrytobecleared.