Enterasys Matrix DFE-Gold Series

clear port inlinepower Configuring Power over Ethernet (PoE)
Enterasys Matrix DFE-Gold Series Configuration Guide 2-71
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoenablePoEonportfe.3.1withcriticalpriority:
Matrix(rw)->set port inlinepower fe.3.1 admin auto priority critical
clear port inlinepower
UsethiscommandtoresetPoEparametersononeormoreportstodefaultvalues.
Syntax
clear port inlinepower port-string {[admin] [priority] [type] [powerlimit]}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtorestthePoEpriorityonportfe.3.1tolow:
Matrix(rw)->clear port inlinepower fe.3.1 priority
port‐string Specifiestheport(s)onwhichtoconfigurePoE.
adminoff|auto SetsthePoEadministrativestatetooff(disabled)orauto(on).
prioritycritical|high
|low
Setstheport(s)priorityforthePoEallocationalgorithmtocritical 
(highest),highorlow.
typetype Specifiesastringdescribingthetype
ofdeviceconnectedtoaport.
powerlimit
powerlimit Sets themaximumpowerallowedonthisportinmegawatts.Valid
valuesare0‐15400.
port‐string Specifiestheport(s)onwhichtoresetPoE.
admin ResetsthePoEadministrativestatetoauto(on).
priority Resetsthe port(s)priorityforthePoEallocationalgorithmtolow.
type Resetstheporttypetoanemptystring.
powerlimit Resetsthemaximumpowerto15400megawatts.