Enterasys Matrix DFE-Gold Series

set spantree bridgeprioritymode Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-19
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheSpanningTreebridgeprioritymodesetting:
Matrix(rw)->show spantree bridgeprioritymode
Bridge Priority Mode is set to IEEE802.1t mode.
set spantree bridgeprioritymode
UsethiscommandtosettheSpanningTreebridgeprioritymodeto802.1D(legacy)or802.1t.This
willaffecttherangeofpriorityvaluesusedtodeterminewhichdeviceisselectedastheSpanning
Treerootasdescribedinsetspantreepriority(“setspantreepriority ”onpage 6‐20).
Syntax
set spantree bridgeprioritymode {8021d | 8021t}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtosetthebridgeprioritymodeto802.1D:
Matrix(rw)->set spantree bridgeprioritymode 8021d
clear spantree bridgeprioritymode
UsethiscommandtoresettheSpanningTreebridgeprioritymodetothedefaultsettingof802.1t.
Syntax
clear spantree bridgeprioritymode
Parameters
None.
8021d Setsthebridgeprioritymodetouse 8 02.1D(legacy)valuesofvalues,
whichare0‐65535.
8021t Setsthebridgeprioritymodetouse802.1tvalues,whichare0‐61440,
inincrementsof4096.Valueswillberoundedupordown,depending
onthe802.1tvaluetowhichtheentered
valueisclosest.