Enterasys Matrix DFE-Gold Series

clear sntp server Configuring Simple Network Time Protocol (SNTP)
Enterasys Matrix DFE-Gold Series Configuration Guide 13-5
Example
ThisexampleshowshowtosettheserveratIPaddress10.21.1.100asanSNTPserver:
Matrix(rw)->set sntp server 10.21.1.100
clear sntp server
UsethiscommandtoremoveoneorallserversfromtheSNTPserverlist.
Syntax
clear sntp server {ip-address | all}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoremovetheserveratIPaddress10.21.1.100fromtheSNTPserverlist:
Matrix(rw)->clear sntp server 10.21.1.100
set sntp broadcastdelay
Usethiscommandtosettheroundtripdelay,inmicroseconds,forSNTPbroadcastframes.
Syntax
set sntp broadcastdelay time
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
ip‐address SpecifiestheIPaddressofaservertoremovefromthe SNTPserverlist.
all RemovesallserversfromtheSNTPserverlist.
time Specifiesbroadcastdelaytimeinmicroseconds.Validvaluesare1to
999999.Defaultvalueis3000.